Motorcycle Throttle & Choke cables para Honda CB125S

Motorcycle Throttle and Choke Cables for Honda CB125S

Because wear is natural when riding your Honda CB125S motorcycle, it is important to keep up with maintenance or replacement of its sensitive moving parts. Choke, clutch, and throttle cables are exposed to the elements and debris constantly, so you should monitor these parts for any signs of degradation. Knowing what types of cables are available and how to install them on your motorcycle are both important considerations for any CB125S bike owner.

The choke, clutch and throttle cables all interact with your motorcycles engine in various ways. These cables are constructed of one or more braided wires and themselves contain small moving parts. Although they are sheathed in a durable sleeve, often with a protective coating, these parts will still experience wear over time. The throttle controls the acceleration of your motorcycle, so without a working throttle cable, the vehicle will not run. Faulty wiring of any type may detrimentally affect the performance of your motorcycle.

Motorcycle throttle cables consist of a pair of braided steel wires. This apparatus is one pair of wires, but larger motorcycles may have more than one throttle cable. Throttle cables allow you to accelerate your motorcycle by opening and closing the engines carburetor when you press or release the throttle mechanism. Throttle cables perform a similar function to a gas pedal on a car, but are placed in a different location for convenience and safety.

Occasionally, you may need to adjust the throttle cables on your Honda if they are too long or too short. You will also need to perform some adjustments if you are replacing old throttle cables. Improperly adjusted motorcycle cables can have a deleterious effect on the performance of your Honda.

1. Loosen the cables by tweaking the adjusters attached to them. The adjusters are steel nuts that are wrapped around the cables.
2. Take out the switch housing apparatus. The switch housing looks like a black box that is attached to your handlebar.
3. You will need to put some lubricant on the end of each cable before you reattach the housing.
4. Level the carburetor by keeping the throttle open all the way and pulling the cable all the way out. Once the throttle cable is almost completely out, check that the butterfly on the bikes manifold is also level.